CEL DELETE INSTALL GUIDE

CEL DELETE CONTENTS

INSTALLING THE CEL DELETE

This is what the final product will look like installed (downpipe may vary).

Step 1) 

Remove the Post-Cat. O2 Sensor(Farthest from turbo). Unscrew using a O2 Sensor socket (22mm Socket, Shown below)

Step 2)

Install the CEL Delete with the adjustment nut tightened all the way flush with the angled portion as shown below. Screw the CEL Delete into the post-catalyst O2 sensor bung. Have the CEL Delete face a direction that will prevent contact with any components.  This position will vary depending on your application. 

Step 3)

Install the O2 Sensor. Screw the O2 Sensor into the straight portion of the CEL Delete

SUMMARY

This will keep a CEL off of your dash! Make sure you clear the codes after installation if any existed prior to installing the CEL Delete.

*Disclaimer* In some situations fine tuning of the CEL Delete will take place with the adjustment nut. If this happens, and your CEL comes back on, read the code and send it in to getarmed@armmotorsports.com and our tech support will assist you.

DISCLAIMER

This product is for Off-Road Use Only. Items sold for off-road use only are illegal to use on public roads in most states and provinces. This product is intended for racing vehicles which may never be used on a public road.